News
:
This forum is now permanently frozen.
m0n0wall Forum
>
m0n0wall Support (English)
>
Hardware
Topic: WRAP in a rackmount...
Pages: [
1
]
Topic: WRAP in a rackmount... (Read 3620 times)
WRAP in a rackmount...
« on: March 27, 2007, 00:51:17 »
pjo
Posts: 4
So... as the title says does anyone have any pictures of their setup with rackmounts? I am looking to finally move a setup of 2 x WRAP1-2 into a rackmount setup, so I am looking for ideas...
pjo
Re: WRAP in a rackmount...
« Reply #1 on: March 29, 2007, 06:54:46 »
cmb
Posts: 851
I don't think I have any pictures readily available, but I do have a 1U case that holds two WRAP boards. I don't recall offhand where it's from, it was a donation to pfsense from a company that sells them. It's at the colocation facility that hosts the pfsense servers and some of the m0n0wall sites. If you're curious I can get specifics. I recall they're pretty expensive though, about $300 USD IIRC for just the case.
Re: WRAP in a rackmount...
« Reply #2 on: March 29, 2007, 19:01:06 »
sullrich
Posts: 2
I believe what you seek is this:
http://www.yawarra.com.au/hw-eber.php
Re: WRAP in a rackmount...
« Reply #3 on: March 30, 2007, 00:00:26 »
bitonw
Posts: 79
http://www.kd85.com/
it's a soekris board but they are almost the same...
Re: WRAP in a rackmount...
« Reply #4 on: March 31, 2007, 20:48:45 »
cmb
Posts: 851
Quote from: sullrich on March 29, 2007, 19:01:06
I believe what you seek is this:
http://www.yawarra.com.au/hw-eber.php
Right vendor, wrong product.
what I spoke of is:
http://www.yawarra.com.au/product.php?productCode=HW-WR11-R
Pages: [
1
]
Topic: WRAP in a rackmount...