News
:
This forum is now permanently frozen.
m0n0wall Forum
>
m0n0wall Support (English)
>
Firewall/NAT
Topic: Monowall can use Bridge transparent mode firewall ??
Pages: [
1
]
Topic: Monowall can use Bridge transparent mode firewall ?? (Read 9316 times)
Monowall can use Bridge transparent mode firewall ??
« on: September 17, 2008, 14:55:11 »
Oracle
Guest
Hello Alls,
I don't know monowall can used Bridge transparent mode.(no nat route mode).
I'm mend in configure below.
Internet (32 Public IP/128 V4 ) <---nic eth0 --> monowall server <----> nic eth1-->Switch (All public IP/128)
If it can make in above How to config ? and How to assign ip manage monowall in mamu ?
Anybody know?
Thanks
Bancha K.
Re: Monowall can use Bridge transparent mode firewall ??
« Reply #1 on: September 20, 2008, 23:50:40 »
cmb
Posts: 851
this type of setup is described here.
http://doc.m0n0.ch/handbook/examples-filtered-bridge.html
Re: Monowall can use Bridge transparent mode firewall ??
« Reply #2 on: July 01, 2014, 08:12:50 »
naitsabes84
Posts: 1
Hi,
I want to use such a setup. I installed the current image 1.8.1 but i do not find the configuration entrys....
13.3.3. OPT Interface Configuration
13.3.4. Enable Filtering Bridge
Is V1.8.1 still useable in transparent mode?
Thanks
Sebastian
Re: Monowall can use Bridge transparent mode firewall ??
« Reply #3 on: July 01, 2014, 14:56:21 »
Fred Grayson
Posts: 994
The documentation is not current.
From the change log regarding Enable Filtering Bridge:
1.3b17
------
- Convert from BRIDGE to if_bridge. Remove multi-interface bridge check,
and checkbox under System > Advanced for filtering bridge since member
interfaces will always be filtered.
For your OPT Interface, Interfaces: Optional 1 (OPT1) | Primary configuration, set "Bridge with" there.
--
Google is your friend and Bob's your uncle.
Pages: [
1
]