News: This forum is now permanently frozen.
linktree m0n0wall Forum  >  m0n0wall Support (English)  >  Firewall/NAT
linktree Topic: Accessing Draytek 100 series PPPoA/E bridge?
Pages: [1]
Topic: Accessing Draytek 100 series PPPoA/E bridge?  (Read 1386 times)
« on: September 17, 2008, 23:01:49 »
HairyMonster *
Posts: 18
Trying to configure m0n0wall to allow access to the web interface of a Draytek 100 series PPPoA/E bridge, and having no luck. I've had this working for other modems. I think I must be having a stupid moment.

I've configured Advanced Outbound NAT with the following:
Interface-Source-Destination-Target
WAN-10.11.12.0/24-192.168.1.0/24-192.168.1.2     
WAN-10.11.12.0/24-!192.168.1.0/24

I've unblocked the private networks on WAN, and added a proxy arp on 192.168.1.2.

There's nothing of note logged.

Attempting to ping from LAN to 192.168.1.1 comes back with an unreachable from the LAN IP.

Is it possible to do this when WAN is configured as PPPoE? Anyone had any success with accessing the Drayteks in this manner?
HM.
« Reply #1 on: September 17, 2008, 23:06:59 »
HairyMonster *
Posts: 18
Duh. I was being stupid. It's late Sad
Must learn to read properly before posting...

http://wiki.m0n0.ch/wikka.php?wakka=AccessingModemOutsideFirewall

Offtopic: Has anyone been able to change the IP address successfully on a Draytek 110? This one I'm using refuses to boot correctly afterwards and I have to factory-reset.
« Last Edit: September 17, 2008, 23:29:25 by HairyMonster »
HM.
 
Pages: [1]
 
 
Powered by SMF 1.1.20 | SMF © 2013, Simple Machines