General Questions

Hi,

I have the network installation listed below:

                                              |---> 10.53.10.10 (Wan - Mono) ------|----> 10.53.11.1/24 (Lan - Mono)
                                              |
-->10.53.10.1(Internet)----->|
                                              |
                                              |---> 10.53.10.9 (Wan - Mono - 2) ---|---> 172.16.5.1/24 (Lan - Mono - 2)

Is there a way to setup static route or NAT to enable client on (Lan - Mono), to access (Lan - Mono - 2) and vice versa. 

Regards

It gets a bit complicated in this scenario as you have NAT on both mono's.  It would be far simpler to have 1 monowall with 3 network cards.  Is this not possible?

It's is possible, but i use traffic shaping to divide the bandwidth between the users.
On mono, i have 13 users sharing a 512 download and upload speed. some of them are abusing the network by using pair to pair and bit torrent clients. who abuse the network i lower his speed to a modem speed, or sometimes disconnect him from the network through a firewall rule.

on mono-2, i have more then 100 users, so i use traffic shaping and firewall to isolate the users who abuse the network.

let me explain it in another way, mono for VIP users, Mono-2 for normal clients.

Regards