General Questions

If I'm repeating this question I apologize, I didn't see any answer to the following question.

Scenario

1. Wrap 2c board with 2 wifi cards and 1 nic

Wan is one wireless card the connects to our backhaul and then the internet.  This is working great.  10.254.20.123

Lan is the nic that is on the wrap board  192.168.1.1

Opt1 is going to be our hotspot wireless radio. and is on the same ip subnet at the Lan

To get the Opt1 wireless card on the internet I had to bridge the OPT1 to the Lan so that it could get an IP address (I hope I did this right because I can get to the internet)

Issue
I want to use the captive portal function for the hotspot users but I cannot activate it because it will not work when Opt1 is bridged to Lan.

Is there a fix or a configuration that I can not aware of?

Second question I cannot administer the monowall from the 10.254.20.x network for some reason.  What would cause this?

Ok figured it out.

Using the serial cable to did the following

sis0 to the opt1
ath0 to the wan
aht1 to the lan

Problem that I find now is the I cannot bridge the sis0 to the wan or lan because on the lan side I have the captive portal turned on and on the wan side I'm running the wireless card as a client bss