General Questions

I have monowall (version 1.235) configured as follows:

WAN - 128.101.189.59
LAN #1 - 160.94.70.254 /25
LAN #2 - 172.1.0.254 /16
LAN #3 - 11.17.1.1 /16

The firewall rules are very simple.  Allow everything from and to the LANs, blocking everything inbound on the WAN.  The one and only rule on each of the LAN firewall configurations looks like this: Proto * Source * Port * Destination * Port *.

Traffic passes between LAN1 and LAN2 without any problem and from LAN1 and LAN2 to the WAN.

LAN #3 is a new network that I just recently attached but I cannot pass any traffic either to or from that LAN to the WAN or the other LAN networks. 

I can ping hosts on LAN #3 from the firewall diagnostics page but those same hosts cannot ping the LAN #3 monowall interface or any host on the other LANs or any host on the WAN.

LAN #3 is plugged into an IBM BladeCenter Chassis that is populated with some odd hardware so I can't definitely place the problem on the monowall configuration. 

Do you see any obvious problems with my set up?  It feels like I'm just over looking something obvious but I just cannot put my finger on it.

Thanks in advance for any advice you may have.

None of your LAN addresses are valid private IPs.  Unless you really own those three public address ranges, you first need to switch your LAN interfaces to valid private IPs.

CS...