News: This forum is now permanently frozen.
linktree m0n0wall Forum  >  m0n0wall Support (English)  >  General Questions
linktree Topic: Only two ports work on net5501
Pages: [1]
Topic: Only two ports work on net5501  (Read 1397 times)
« on: January 23, 2012, 21:58:15 »
gurivis *
Posts: 3
Hi-

I recently installed m0n0wall on Soekris net 5501. Only the first two ports, Eth0 and Eth1 work. Is there any reason, why the other two ports Eth2 and Eth3 on Soekris box don't work?

M0n0wall Version: 1.33

Thanks
Sridhar
« Reply #1 on: January 23, 2012, 23:34:23 »
Fred Grayson *****
Posts: 994
They should work. Did you configure them from the console or the WebGUI?
--
Google is your friend and Bob's your uncle.
« Reply #2 on: January 24, 2012, 03:25:54 »
gurivis *
Posts: 3
WebGui
« Reply #3 on: January 24, 2012, 14:44:24 »
Fred Grayson *****
Posts: 994
Try this and see what happens. Reconfigure such that your WAN and LAN are now on eth2 and eth3 and disable eth0 and eth1. Do they work now? If so, try enabling eth0 and eth1 one at a time and see if they work too.
--
Google is your friend and Bob's your uncle.
« Reply #4 on: January 24, 2012, 20:40:01 »
gurivis *
Posts: 3
How do I reconfigure ports for interfaces? In the web GUI management, I see "Interfaces (assign)"... But, that is for assigning IP-address blocks. Is there a way to enable/disable the interfaces.

Thanks
« Reply #5 on: January 24, 2012, 20:59:03 »
Fred Grayson *****
Posts: 994
Click on Interfaces (assign), not the LAN and WAN below. From there you change the ports used via the drop down lists.
--
Google is your friend and Bob's your uncle.
 
Pages: [1]
 
 
Powered by SMF 1.1.20 | SMF © 2013, Simple Machines