Hi!
I use a Nokia IP120 which has following hardware specifications
Geode processor - National GX1 300 MHz
128 MB RAM
5 GB laptop hard drive
Three 10/100 Ethernet ports
Two serial ports (console and auxiliary)
I was eager to try the new 1.3b today, so I decided to upgrade my 1.231 to 1.3b4.
But when starting it gave me this via console:
Copyright (c) 1992-2007 The FreeBSD Project.
Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994
The Regents of the University of California. All rights reserved.
FreeBSD is a registered trademark
FreeBSD 6.2-RELEASE-p6 #0: Sun Jul 29 21:28:28 CEST 2007
pci0: <unknown card> (vendor=0x10
root@mb62.neon1.net:/usr/src/sys/i386/compile/M0N0WALL_GENERIC
orm0: <Option ROMs> at iomem 0xe8000-0xebfff,0xec000-
Timecounter "i8254" frequency 1193182 Hz quality 0
pmtimer0 on isa0
CPU: Geode(TM) Integrated Processor by National Semi (266.68-MHz 586-class CPU)dc0: cmd 3 failed at out byte 1 of 3
ata0
Origin = "Geode by NSC" Id = 0x540 Stepping = 0
kbd1 at kbdmux0
ath_hal: 0.9.17.2 (AR5210, AR5211, AR5212, RF5111, RF5112, RF2413, RF5413)
cpu0 on motherboard
pcib0: <Host to PCI bridge> pcibus 0 on motherboard
pir0: <PCI Interrupt Routing Table: 3 Entries> on motherboard
pci0: <PCI bus> on pcib0
Fatal trap 12: page fault while in kernel mode
fault virtual address = 0xeb11f
fault code = supervisor read, page not present
instruction pointer = 0x20:0xc00eb621
stack pointer = 0x28:0xc1c20a54
frame pointer = 0x28:0xc1c20a54
code segment = base 0x0, limit 0xfffff, type 0x1b
= DPL 0, pres 1, def32 1, gran 1
processor eflags = interrupt enabled, resume, IOPL = 0
current process = 0 (swapper)
trap number = 12
panic: page fault
Uptime: 1s
Automatic reboot in 15 seconds - press a key on the console to abort
Rebooting...
My first thought was: Maybe the upgrade process gone wrong, so I formated the Harddisk and used physdiskwrite (latest version from m0n0.ch) to put on 1.3b4 but it gave me the same error.
Also the image can't be corrupt because I booted it on a Compaq Armada nx9010 Laptop and it got to the Setupscreen without problems.
So it must be in the image.
1.231 runs without problems.
Any ideas?
Topic: 1.3b4 crashes on Nokia IP120